Removing and installing transmitter/receiver unit - AR82.70-P-8911DA

MODEL 208.3 as of 1.7.00 with CODE (853) MB standard cellular telephone 

Shown on model 202 

Fig 1: Identifying Transmitter/Receiver Unit Remove/Install Components

	Removal, installation
1	Connect quiescent current retention unit		*WH58.30-Z-1012-09A
	Risk of explosion  from explosive gas. Risk of poisoning and caustic burns  from swallowing battery electrolyte. Risk of injury  from caustic burns to eyes and skin from battery electrolyte or from handling damaged lead acid batteries.	No fire, sparks, naked flames or smoking. Wear acid-protective gloves, clothing and eye protection. Pour battery electrolyte only into suitable and appropriately marked containers.	AS54.10-Z-0001-01A
2	Disconnect ground cable of battery		AR54.10-P-0003A
	Notes on battery	All models.	AH54.10-P-0001-01A
3	Remove floor paneling in trunk
4	Remove cover above control module plate
5	Unscrew nuts (1)
6	Lift off telephone transmitter/receiver (A35/13)	Do not damage connection lines. Do not kink or stretch D2B fiber optic cable.
7	Release connectors on telephone transmitter/ receiver (A35/13) and disconnect
8	Remove telephone transmitter/receiver (A35/13)
9	Install in the reverse order