Remove/install front engine mounts and/or engine support - AR22.10-P-1260HX
ENGINE 601 in model 124, 201 as of 1.4.85
ENGINE 602 in MODEL 124, 201
ENGINE 603 in MODEL 124, 140
Fig 1: Identifying Front Engine Mount Removal/Install Components - Engine 601 & 602 In Model 124, 201, Engine 603 In Model 124, 140
| Fig. item etc. | Work instructions | ||
|---|---|---|---|
| Arrow | Air intake hose | detach | |
| 16, 17, 18 | Detach fan shroud | and lay over fan | |
| 25a, 36, 40, 45 | Remove engine mount, shield | ||
| *BA22.10-P-1001-01J | |||
| *BA22.10-P-1004-01J | |||
| *BA22.10-P-1010-01J | |||
| *WE58.40-Z-1012-11A | |||
| 6 | Observe different version on left and right. Pay attention to environmental protection regulations for disposal; give the engine mount to the mixed scrap. |
| Number | Designation | Engines 601, 602, 603 in models 124, 140, 201 with hydr.engine mount at the front, except engine 603.913/963 (4 MATIC) | Engine 603.913/963 (4 MATIC) in model 124.2/3 | |
|---|---|---|---|---|
| BA22.10-P-1001-01J | Bolt, front engine mount to body/ front axle carrier | Nm | 25 | 25 |
| BA22.10-P-1004-01J | Bolt, front engine support to engine mount | Nm | 55 | 20 |
| BA22.10-P-1010-01J | Bolt, front engine mount to engine support | Nm | - | 55 |
WORKSHOP EQUIPMENT
| WE58.40-Z-1012-11A | Load regulator (engine hoist), self-locking |