Connecting compression tester - AR01.10-P-0010-01A

Fig 1: Identifying Electrical Connection Set (201 589 00 99 00)

Fig 2: Identifying Compression Tester (001 589 76 21 00)

1. Fold open cover (1) of the terminal block (X12/3) at the left wheelhouse next to the fuse and relay box.
2. Connect clamp (A) of the compression tester to the terminal block (X12/3).
   Fig 3: Identifying Cover, Connect Clamp And Terminal Block

   
3. Remove cover above engine/body plug connection (X26/25) at the front left wheelhouse.
4. Pull locking plate of the plug connection (X26/25) forward.
5. Unplug connector of the engine/body plug connection (X26/25).
   Fig 4: Pulling Locking Plate Of Plug Connection Forward

   
6. Plug in adapter cable (07) at pin A1 (arrow) of connector (X26/25).
7. Connect adapter cable (07) with cable (08) to the clamp (B) of the compression tester.
   Fig 5: Identifying Adapter Cable, Pin A1, Connector, Cable And Clamp