Removing and installing lining on C-pillar - AR68.30-P-4490E

MODEL 202.01/02/12 

Fig 1: Identifying Lining On C-Pillar Remove/Install Components - Model 202.01/02/12

	Removal, installation
1	Pull off edge guard in area of lining (1)
2	Unfasten hooks (2, arrows) with long wedge		Figure
3	Press lining (1) out of top rear retaining clip (3)	For this purpose press lining (1) toward center.
4	Pull panelling (1) up out of insert clip (4) and insert tabs (arrows) in rear shelf (5)	To completely remove lining (1) ↓
		remove rear seat cushion	AR91.12-P-1700E
5	Remove screw (6) on rear seat belt end fitting (7) and pull seat belt sash out of lining (1)		*BA91.40-P-1001-01A
6	Reinstall in opposite order

SEAT BELTS/EMERGENCY TENSIONING RETRACTORS

Number	Designation		Model 202, 208.3	Model 208.4	Model 210
BA91.40-P-1001-01A	Bolt on seat belt end fitting	Nm	35	35	35

Special tool 

Fig 2: Identifying Long Wedge (115 589 03 59 00)