Removal and installation of electronic ignition/starter switch (EZS - AR46.10-P-0810B
MODEL 208
Fig 1: Identifying Electronic Ignition/Starter Switch Remove/Install Components - Model 208 (1 Of 3)
Fig 2: Identifying Electronic Ignition/Starter Switch Remove/Install Components - Model 208 (2 Of 3)
Fig 3: Identifying Electronic Ignition/Starter Switch Remove/Install Components - Model 208 (3 Of 3)
| Removal, installation | |||
| 1 | Remove cover below instrument panel | AR68.10-P-1500K | |
| 2 | Unscrew screw from bottom right of instrument panel | ||
| 3 | Unscrew escutcheon (36a) from instrument panel using a claw-type wrench (020) | Figure | |
| 4 | Remove electronic ignition/starter switch (N73) | ||
| 5 | Remove shift lock (36h), by compressing the retaining clips (arrows) and moving the shift lock forwards out of the retaining lugs | ||
| 6 | Disconnect electrical connectors | ||
| 7 | Install in reverse order |