Preparations for distance and comparison measurements - AR40.30-P-0401B
MODEL 170, 202, 208, 210
Model 170
Models 202, 208 with engine 111
Fig 2: Identifying Preparations For Distance And Comparison Measurements - Models 202, 208 With Engine 111 (1 Of 3)
Models 202, 208 with engines 112, 113
Fig 3: Identifying Preparations For Distance And Comparison Measurements - Models 202, 208 With Engines 112, 113 (1 Of 3)
Model 210 except 210.08/28 shown with model 611
Fig 4: Identifying Preparations For Distance And Comparison Measurements - Model 210 Except 210.08/28 Shown With Model 611 (1 Of 3)
Model 210.08/28
Fig 6: Identifying Preparations For Distance And Comparison Measurements - Model 170, 202, 208, 210 (2 Of 3)
Fig 7: Identifying Preparations For Distance And Comparison Measurements - Model 170, 202, 208, 210 (3 Of 3)
| Checking | |||
| 1 | Align vehicle horizontal in the longitudinal direction by loading with suitable weights | Measurement of inclination via door entrance edges, e.g. carry out with a spirit level. | |
| 2 | Screw in threaded bolts (07n) | Insert threaded bolts in the rearmost tapped holes "k" in fixing rail. Depending on the model, unscrew rear bolts from engine suspension or remove plugs for tapped holes. |
|
| 3 | Insert suspension (07) horizontal and adjust supports (07r, 07s) to suit the respective model | The suspension (07) does not have to be at right angles to the longitudinal axis of the vehicle, but may be inclined to it (depending on the position of the rearmost tapped holes in the fixing rail (64)) |
AR40.30-P-0401-01A |
| Figure | |||
| 4 | Install telescopic measuring rod (06) with connecting parts on retaining pin (024b) | Insert respective measuring tips/pins (024) for the corresponding distance or comparative measurement | |
| Figure | |||
| Figure | |||
| Figure | |||
| Figure | |||
| 5 | Carry out distance and comparative measurement at front and rear axle | Models 170, 202, 208 | AR40.30-P-0402A |
| Model 210 | AR40.30-P-0402C |