Removing and installing exterior door handle on front door - AR72.10-P-2400E
MODEL 202
Fig 1: Identifying Exterior Door Handle On Front Door Remove/Install Components - Model 202 (1 Of 2)
Fig 2: Identifying Exterior Door Handle On Front Door Remove/Install Components - Model 202 (2 Of 2)
| Removing | |||
| 1 | Pull door sealing frame out of channel in area of door lock | ||
| 2 | Loosen 4 mm Allen screw (6) | Accessible through duct on end of door, Allen screw (6) is secured against falling by retainer (7). | |
| 3 | First pull guide (2) out toward rear and then toward outside | ||
| 4 | Pull handle (1) and underlay (4) to the rear out of bearing bracket (8) and remove | Handle and guide have chrome insert with Elegance trim. Chrome parts not available separately. Bearing bracket (8) can be removed via access cover in inner door panel. |
|
| 5 | Remove base (5) | ||
| Installing | |||
| 6 | Install base (5) | Bearing bracket (8) installed | |
| 7 | Turn eccentric adjustment screw (10) toward outside | This facilitates installation of door handle | |
| 8 | Install handle (1) and underlay (4) in bearing bracket (8) and guide at the same time into the operating lever(12) of the door lock | ||
| 9 | Insert guide (2) | Guide rotary rod (3) into door lock operator. | |
| 10 | Screw in 4 mm Allen screw (6) and tighten | *BA72.10-P-1005-01A | |
| 11 | Adjust clearance between handle (1) and control lever (12) with eccentric adjustment screw (10) | Accessible via opening (13) on the end of the door. Use cross-head screwdriver. |
*BE72.10-P-1001-01A |
| 12 | Check clearance by pulling on handle (1) until resistance is felt | *BE72.10-P-1001-01A | |
| 13 | Install door sealing frame | ||
| 14 | Carry out operational check |
TEST AND ADJUSTMENT VALUES FOR FRONT DOOR
| Number | Designation | Model 202 | |
|---|---|---|---|
| BE72.10-P-1001-01A | Clearance | mm | 2 (±1) |
| Number | Designation | Model 202 | |
|---|---|---|---|
| BA72.10-P-1005-01A | Screw of door handle of front door | Nm | 3 |