Removing and installing rear bumper - AR88.20-P-2200EA

MODEL 202.07 /08 /18 /093 

Fig 1: Identifying Rear Bumper Remove/Install Components - Model 202.07/08/18

	Removal
1	Remove side paneling in rear on left and right		AR68.30-P-4780A
2	Remove cover on rear center piece		AR68.30-P-4785A
3	Unscrew nuts (1) from inside and remove washers (2)
4	Remove bumper (3) toward rear with helper	Press hump (arrow) on bumper outward (avoid damaging paint)
5	Check gaskets
	Installation
6.1	Transfer AMG bumper	See accessory installation instructions ↓
		Retrofitting AMG paneling sections	AZ88.00-P-0001A
7	Position bumper (3) with helper
8	Install washers (2) and nut (1), do not tighten
9	Align bumper (3)	Check gap "B"↓ If necessary correct by adjusting guide (4) (basic adjustment dimension "A" = 53 mm)	*BE88.20-P-1002-01A
10	Tighten nut (1)		*BA88.20-P-1002-01A
11	Install cover on rear center section		AR68.30-P-4785A
12	Install side paneling on left and right in rear		AR68.30-P-4780A

GAP DIMENSIONS FOR BUMPER

Number	Designation			Model 202
BE88.20-P-1001-01A	Dimension	Front bumper, gap dimension "A"	mm	5
		See figure		AR88.20-P-2000E
BE88.20-P-1002-01A	Dimension	Rear bumper, gap dimension "B"	mm	6
		See figure		AR88.20-P-2200E

BUMPER

Number	Designation		Model 202
BA88.20-P-1002-01A	Nuts for rear bumper on rear center	Nm	20