Removing and installing front fender - AR88.10-P-1000E

MODEL 202.028 /033 /093 

Fig 1: Identifying Front Fender Components - Model 202.028 /033 /093

	Removal, installation
1	Open engine hood and move to upright position		AR88.40-P-1000E
2	Remove front bumper		AR88.20-P-2000E
3	Remove turn signal lamp
4	Remove molding (2) with seal (3)
5	Remove cover (6)
6	Press off cover (7)		Fig 2
7	Unscrew screws (8)
8	Unscrew screws (9), after opening front door
9	Unscrew screws (10)
10	Remove fender (1) upward	When the front fender is replaced install turn signal lamp bracket (4) on new fender
11.1	Bend over edge on fender	Models 202.028/033/093 C 36 and C 43 AMG and vehicles with 7.5 J x 17 H2 ET 35 AMG wheels	AR88.10-P-1000-01B
12	Apply permanent MB underbody protection agent to replacement fender
13	Reinstall in opposite order	When installing ensure that fender is positioned correctly in relation to front door and engine hood, the inner fender seal must make contact
14	Preserve hollow cavities

Special tool 

Fig 2: Identifying Installation Wedge (110 589 03 59 00)