Removing and installing deflector for retaining hook - AR88.40-P-3300A
MODEL 202 up to 31.10.93
MODIFICATION NOTES
| 21.10.99 | Replaces SI 88/35 dated 21.4.94 | Remove SI 88/35 from your file. |
| Removing, installing | |||
| 1 | Remove deflector. | ||
| Deflector for retaining hook with additional installation hook | Model 202 | BT88.40-P-0001-01A | |
| 2 | Measure upper frame cross member according to dimensions X and Y specified and mark (arrow). | ||
| Engine hood | Model 202 | *BE88.40-P-1001-01A | |
| 3 | Center-punch marked point. | ||
| 4 | Drill center-punched point (arrow). | Use approx. 8 mm bit. | |
| 5 | Deburr hole. | ||
| 6 | Paint hole to match color of car. | ||
| 7 | Install deflector (C). |
ADJUSTMENT VALUES FOR ENGINE HOOD
| Number | Designation | Model 202 up to 10/93 | ||
|---|---|---|---|---|
| BE88.40-P-1001-01A | Deflector for retaining hook | Dimension "X" | mm | 68 |
| Dimension "Y" | mm | 4.5 | ||
| See figure | - | |||