Removing and install engine hood lock - AR88.40-P-3200E

MODEL 202 

MODIFICATION NOTES

27.7.00

Greasing or lubricating engine hood lock no longer permissible

Step 6

Fig 1: Identifying Engine Hood Lock Remove/Install Components - MODEL 202

	Removing
1	Open engine hood		AR88.40-P-1000E
2	Unclip clips (2) from upper frame cross member (5)
3	Remove cover (1)	Vehicles with air conditioning: For removing cover and engine hood lock remove upper frame cross member.
4	Unhook engine hood lock release cable (10) from engine hood lock (3)
5	Unscrew screws (4) and remove engine hood lock (3) upward
	Installation
6	Insert engine hood lock (3) into upper frame cross member (5) from top and tighten with screws (4)		*BA88.40-P-1003-01A
7	Hook engine hood lock release cable (10) in at engine hood lock (3)	Ensure that engine hood lock release cable is routed properly.
8	Insert cover (1) and press in clips (2)
9	Perform function check
10	Close engine hood
11	Check engine hood fit	if necessary ↓
		Adjust engine hood	AR88.40-P-3020E

ENGINE HOOD

Number	Designation		Model 202
BA88.40-P-1003-01A	Screw on engine hood lock	Nm	10