Removing and installing headlamp range adjustment control module - AR82.10-P-4081B

MODEL 129 as of 1.6.96 with CODE (612b) Xenon headlamp unit 

Fig 1: Identifying Headlamp Range Adjustment Control Module (2 Of 2)

	Removing, installing
1	Remove cover below instrument panel on right
2	Disconnect plug connector (1) from headlamp range adjustment control module (N71)
3	Remove headlamp range adjustment control module (N71)
4	Install in the reverse order
5	Adjust zero position of headlamps with HHT	See Diagnosis Manual, Body
6	Check headlamp adjustment and if necessary correct.		AP82.10-P-8260A