Removing and installing center high-mounted stop lamp - AR82.10-P-5375A

MODEL 129 as of 1.6.96 

Fig 1: Identifying Center High-Mounted Stop Lamp Components

OPERATION NO. OF OPERATION TEXTS OR OF STANDARD TEXTS AND FLAT RATES

Operation no.

Operation text

	Removal, installation
1	Remove paneling on trunk lid
2	Remove plug (1)	For this purpose, turn plug (1) counter clockwise and remove.
3	Remove cover (3)	For this purpose, turn plug (2) counter clockwise and remove cover (3).
4	Remove lens (4)	Carefully insert installation wedge between lens and trunk lid. Unclip lens.	Figure
5	Unscrew screws (7)
6	Remove reflector (5) together with diode carrier plate (6)	For this purpose, carefully pull out reflector (5) together with diode carrier plate (6) and slide to right in hollow space in trunk lid until the left side of the component can be removed from the opening first.
7	Unclip diode carrier plate (6) from reflector (5)
8	Install in opposite order
9	Check function

Fig 2: Identifying Installation Wedge (110 589 03 59 00