LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1997 >> E320 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overall Vehicle -- Self-Diagnostic System -- 210 Chassis >> Self-Diagnostic System >> Extended vehicle network (EVN) diagnosis operational check actual values interior lights - AD00.19-P-3001A

Extended vehicle network (EVN) diagnosis operational check actual values interior lights - AD00.19-P-3001A

MODEL 202 as of 1.6.97, 208, 210.081 /281, 210 as of 1.3.97 

  Extended vehicle network (EVN) diagnosis, previous knowledge   AD00.19-P-2000A 
I Fuses in order.    
II Battery voltage >11 V    
III Connect Hand-Held Tester to data link connector (DTC readout) (X11/4) in accordance with connecting diagram   AD00.00-P-1000AZ 
IV Voltage supply of control modules and CAN data buses in order.   AD00.19-P-6000A 
V All CAN data buses contacted    
  Function check     
Test step/Scope of test  HAND-HELD TESTER Operation/Requirement  Specified value  Possible cause/Remedy 
1 DBE Operate rear dome lamp switch √
  • Overhead control panel control module (N70)
Rear dome lamp switch (N70s2)
(not on model 208.4)
    O
2 DBE Operate door contact ON/OFF switch ON
  • Overhead control panel control module (N70)
Door contact ON/OFF switch (N70s3)     OFF
3 DBE Operate dome lamp ON/OFF switch ON
  • Overhead control panel control module (N70)
Dome lamp ON/OFF switch (N70s4)     OFF
4 DBE Operate reading lamp switch ON
  • Overhead control panel control module (N70)
Reading lamp switch (N70s5)
Model 208.4: Switch for left front reading lamp (N70s6), switch for right front reading lamp (N70s7)
    OFF
5 DBE Dome lamp ON/OFF switch (N70s4): OFF  ON
  • Overhead control panel control module (N70)
Actuation of dome lamp HHT: Actuation menu   OFF
  Press "F2" button  
    Press "F2" button  
6 DBE Reading lamp switch (N70s5): OFF  ON
  • Overhead control panel control module (N70)
Actuation of reading lamp(s) Model 208.4: Switch for left front reading lamp (N70s6), switch for right front reading lamp (N70s7): OFF    OFF
  Press "F2" button  
    Press "F3" button  
7 TSG 1 HHT: Actuation menu ON AD00.19-P-6000-79A 
Actuation of driver's entrance/exit lamp Press "F2" button   OFF
  • Front driver-side door control module (N69/1)
  Press "F3" button
8 TSG 2 HHT: Actuation menu ON AD00.19-P-6000-79A 
Actuation of front passenger's entrance/exit lamp Press "F2" button   OFF
  • Front passenger-side door control module (N69/2)
  Press "F3" button
9 TSG 3 HHT: Actuation menu ON AD00.19-P-6000-80A 
Actuation of left rear door entrance/exit lamp Press "F2" button   OFF
  • Rear driver-side door control module (N69/3)
  Press "F3" button
10 TSG 4 HHT: Actuation menu ON AD00.19-P-6000-80A 
Actuation of right rear door entrance/exit lamp Taste "F 2" actuate   OFF
  • Front driver-side door control module (N69/4)
  Taste "F 3" actuate
11 TSG 1 Ignition: ON  ON AD00.19-P-6000-79A 
Driver's entrance/exit lamp Open driver's door   OFF AD80.20-P-6000B
  Close
  • Rear passenger-side door control module (N69/1)
12 TSG 2 Ignition: ON  ON AD00.19-P-6000-79A 
Front passenger's entrance/exit lamp Open front passenger-side door   OFF AD80.20-P-6000B
  Close
  • Front passenger-side door control module (N69/2)
13 TSG 3 Ignition: ON  ON AD00.19-P-6000-80A 
Left rear door entrance/exit lamp Open left rear door   OFF AD80.20-P-6000B
  Close
  • Rear driver-side door control module (N69/3)
14 TSG 4 Ignition: ON  ON AD00.19-P-6000-80A 
Right rear door entrance/exit lamp Open right rear door   OFF AD80.20-P-6000B
  Close
  • Rear passenger-side door control module (N69/4)
15 DBE HHT: Actuation menu ON
  • Overhead control panel control module (N70)
On model 208.4 only: Actuation of gong (N70h1) Press "F2" button   OFF
  Press "F3" button