Complaints in connection with a stored fault code - ETC troubleshooting - AD27.19-P-5008-01E
Complaint:
- Target gear is not reached, transmission in mechanical/hydraulic limp-home mode
Fault code:
055 151 P0 730
| Possible cause | Remedy |
|---|---|
| Oil filter not assembled | Assemble oil filter |
| Wiring harness damaged, short-circuit, chafing mark | Check wiring harness to ground. |
| Shift pressure control solenoid valve (Y3/6y2) blocked (foreign matter) | Replace solenoid valve. |
| Control, shift or command valve blocked (foreign matter) | Check slide valve for end position and ease of movement, free off if necessary. |
| The spring in the control spool pressure regulating valve may be broken | Replace spring (part no.140 993 58 01). |