Installing adjusting rings - AR40.20-P-0322-04A
Models 210.08/28
- Raise vehicle at front.
- To adjust camber and caster, the centering washers (19e) fitted as standard must be replaced by the adjusting rings (19d).
The mounting bolt (19) is centered in the oblong hole by the adjusting rings (arrows). By inserting the adjusting rings the mounting bolt (19) can be installed in the right or left position, which adjusts the wishbones by 3 mm inwards or outwards.
Do not tighten the hexagon nut yet so that the wishbone rubber mounts can rotate when the suspension deflects.
Provision for adjustment, camber
| Rear wishbone mount in mm | Camber change | Front wishbone mount in mm | Caster change |
| -3 | +20' | -3 | ± 0 |
| +3 | -20' | +3 | ± 0 |
Provision for adjustment, caster
| Rear wishbone mount in mm | Chamber change | Front wishbone mount in mm | Caster change |
| ± 0 | ± 0 | -3 | +25' |
| ± 0 | ± 0 | +3 | - 25' |
Provision for adjustment, camber and caster
| Rear wishbone mount in mm | Chamber change | Front wishbone mount in mm | Caster change |
| -3 | +20' | ± 0 | - 25' |
| +3 | -20' | ± 0 | +25' |
| -3 | +20' | +3 | - 50' |
| +3 | -20' | -3 | +50' |