Checking rear axle camber - AR40.20-P-0331FB

MODEL 210 with CODE (979) Special protection version with CODE (Z04) Light armoring with CODE (Z06) B6 armoring

Fig 1: Identifying Rear Axle Camber

G04624842

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Inspecting
1.1	Check vehicle level at front and rear axle and adjust, if necessary	With Mercedes-Benz measuring device.	AR40.20-P-0300FB
1.2	Check vehicle level at front and rear axle with electronic inclination measuring instrument and adjust, if necessary	With electronic inclination measuring instrument.	AR40.20-P-0301FB
2	Check camber at rear axle	The camber cannot be adjusted at the rear axle. Large deviations at the rear wheel camber may be caused by the following: Difference in vehicle level too great between the left and right side of the vehicle. Bent camber strut. Frame floor damaged due to an accident. Difference in level at the mounting points for the rear axle carrier between the left and right side of the body. Experience shows that bending caused by an accident also has an effect on the toe.	*BE40.20-P-1001-09B

Test values for rear axle camber

Number	Designation			Model 210.0/2
BE40.20-P-1001-09B	Camber at vehicle level	+40 mm	° ∠ 3.0	-0° 42' (± 30')
		+30 mm	° ∠ 2.0	-0° 52' (± 30')
		+20 mm	° ∠ 2.0	-1° 04' (± 30')
		+10 mm	° ∠ 0	-1° 17' (± 30')
		0 mm	° ∠ -1 .1	-1° 30' (± 30')
		-10 mm	° ∠ -2 .1	-1° 44' (± 30')
		-20 mm	° ∠ -3 .1	-1° 59' (± 30')
		-30 mm	° ∠ -4 .1	-2° 16' (± 30')
		-40 mm	° ∠ -5 .1	-2° 34' (± 30')
		-40 mm	° ∠ -5.1	-2° 34' (± 30')
		-50 mm	° ∠ -6.1	-2° 52' (± 30')