Attaching Mercedes - Benz quick-clamp holder - AR40.20-P-0230FB

MODEL 210 with CODE (979) Special protected version with CODE (Z04) Light armor plating with CODE (Z06) B6 armor plating 

Fig 1: Identifying Mounting Holes

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying MB Quick-Clamp Holders

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Installing, removing
	Inspect MB quick-clamp holders, wheel mirrors or measurement recorders at regular intervals as specified by manufacturer
1	Attach MB quick-clamp holders to front and rear wheels. Take off tensioning grips.	The mounting bell is centered by means of the tracer pins at the 5 mounting holes (arrows) in the disk wheel relative to the front wheel hub or the rear axle shaft flange, respectively.	Figure
2	Install wheel mirror or measurement recorder

Fig 3: Identifying Quick-Clamp Holder (124 589 01 31 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.