Removing, installing rubber boot and sealing ring - AR46.10-P-0600-07BF

Torque Specification

Number	Designation		Model 210
BE46.10-P-1001-01C	Dimension "k" between notch for steering coupling and rear sealing ring on lower steering shaft	mm	173.5
BE46.10-P-1001-01C		Fig. see	AR46.10-P-0600-07BF

Repair materials

Number	Designation	Order number
BR00.45-Z-1046-06A	Klueber Polylub GLY 801 grease	A 001 989 84 51

Removing

Pull off rubber boot (85a).
Unscrew sleeve of sealing ring (79a) and remove sealing ring.

Fig 1: Identifying Sleeve Of Sealing Ring
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Installing
Push on sealing ring (79a).
Adjust dimension (k ) between sealing ring (79a) and sealing ring (75b).
Screw on sleeve of sealing ring (79a).

Fig 2: Identifying Dimension Between Sealing Ring
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Grease rubber boot (85a) at the appropriate locations (arrows) with Isoflex Topas NCA 152 grease.
Push on rubber boot (85a) and press into lower bearing.
Check concerting shape of rubber boot and correct if necessary.
Check movement of rubber boot (85a) on the bearing and correct seating on bearings if necessary.

Fig 3: Identifying Rubber Boot
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.