Detaching console from jacket tube and attaching - AR46.10-P-0600-10BF

Jacket tube

Number	Designation			Model 210
BA46.10-P-1005-03D	Gearbox of height adjustment up/down motor to jacket tube	1st stage	Nm	8
		2nd stage	Nm	3
		Assembly note	See	AR46.10-P-0600-10BF
BA46.10-P-1006-03D	Console to jacket tube	1st stage	Nm	8
		2nd stage	Nm	3
		Assembly note	See	AR46.10-P-0600-10BF
BA46.10-P-1007-03D	Bolt of clamping nut		Nm	6
BA46.10-P-1012-03D	Gearbox of height adjustment up/down motor to console		Nm	10

Detaching

Unclip longitudinal adjustment forward/back motor connector (M20x1). To do this, press the lug (arrow) to the left.

Fig 1: Identifying Unclip Longitudinal Adjustment Forward/Back Motor Connector
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Loosen bolt of clamping nuts (87e) and unscrew clamping nuts.
Remove bolts (87d) with guide bushes.
Remove console (87).
Attaching
Mount console (87).
Insert bolts (87d) and guide bushes.

Check guide bushes and replace if necessary.
Screw on clamping nut (87e) and attach bolt of clamping nut.

The smooth surface of the clamping nut (87e) must point outwards.

Fig 2: Identifying Clamping Nut, Bolt, Guide Bushes And Mount Console
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Tighten bolts (87d), loosen again and retighten, observing the specified tightening torques.
Tighten bolt of clamping nut (87e).
.1 If the gearbox of the height adjustment up/down motor has been removed; align the jacket tube. Tighten the bolts (60a) on the right-hand side. Press the left-hand side slightly to the right with a screwdriver above the spring (arrow) and tighten bolts (60a).
11 Clip on longitudinal adjustment forward/back motor connector (M20x1).