LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1997 >> E320 >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Power Seats - E55, E300, E320 & E430) >> System Tests (Power Seats) >> Test 6: Front Height Switch Resistance

Test 6: Front Height Switch Resistance

WARNING: This page is about a different car, the 1999 Mercedes-Benz E55, 1998 Mercedes-Benz E430, 1998 Mercedes-Benz E320, and 1998 Mercedes-Benz E300. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect appropriate power seat control module harness connector No. 1. See Figure. Measure resistance between harness connector terminals No. 4 and 12. When power seat switch is in front up position, approximately 43 ohms should exist. In front down position, approximately 16 ohms should exist. In neutral position, greater than 20 k/ohms should exist. If resistance is as specified, front height switch resistance is okay at this time. If resistance is not as specified, check wiring. See WIRING DIAGRAMS . If wiring is okay, replace power seat switch.

scientia non olet · About LEMON Manuals