Measure piston ring end clearance - AR03.10-P-7311-02V
Inspection data for piston rings
| Number | Designation | Engine 112.910/911/912 | Engines 112.920/ 921/922/923/ 940/941/942/ 943/944/945/ 946/947/948/ 960, Engine 113.940/941/942/943 | Engines 113.944/980/ 981/982/984 | ||
|---|---|---|---|---|---|---|
| BE03.10-P-1002-05B | Piston ring end gap | Groove 1 | mm | 0.200...0.350 | 0.200...0.350 | 0.200...0.350 |
| Groove 2 | mm | 0.200...0.400 | 0.200...0.400 | 0.200...0.400 | ||
Inspection data for piston rings
| Number | Designation | Engines 113.960/961/ 962/963/964/ 965/968/971 | Engine 113.967 | ||
|---|---|---|---|---|---|
| BE03.10-P-1002-05B | Piston ring end gap | Groove 1 | mm | 0.200...0.350 | 0.200...0.350 |
| Groove 2 | mm | 0.200...0.400 | 0.200...0.400 | ||
Commercially available tools
| Number | Designation |
| WH58.30-Z-1004-12A | Feeler gauge |
- Clean cylinder wall.
- Insert the two compression rings one after the other into the unworn area of the cylinder barrel and measure the end gap with a
feeler gauge. Replace the piston rings if necessary.
The gap clearance of the oil scraper ring cannot be checked because of its three-part design. The oil scraper ring must also be replaced when the compression rings are replaced.