Remove cylinder liner - AR01.40-P-9272A

ENGINES 604, 605, 606 / 

Fig 1: Removing Cylinder Liner

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove
1	Press out cylinder liners		Fig 2
2	Thoroughly clean basic bore
3	Measure basic bore in crankcase	If the bore Ø is exceeded, install new crankcase	*BE01.40-P-1007-02B
			Figure
			*WH58.30-Z-1011-12A
			*WH58.30-Z-1012-12A
			*WH58.30-Z-1002-12A

Inspection data of crankcase

Number	Designation			Engine 604.910/912
BE01.40-P-1007-02B	Bore Ø for cylinder liner in crankcase	D2	mm	91,500...91,535
		Fig. see		-

Inspection data of crankcase

Number	Designation			Engine 604.915/917, 605.91/96, 606.91/96
BE01.40-P-1007-02B	Bore Ø for cylinder liner in crankcase	D2	mm	90,000...90,035
		Fig. see		-

Fig 2: Identifying Drift (603 589 00 15 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying Dial Gage (001 589 53 21 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Commercially available tools

Number	Designation
WH58.30-Z-1002-12A	Micrometer
WH58.30-Z-1011-12A	Internal measuring instrument
WH58.30-Z-1012-12A	Setting gage for micrometer