Disconnecting, connecting engine wiring harness - AR01.00-P-2410H

ENGINE 604, 605, 606 in MODEL 210 as of 1.6.96 

Fig 1: Identifying Engine Wiring Harness Components (2 Of 2)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Removal, installation
1	Disconnect ground cable (W10) of battery		AR54.10-P-0003A
2	Remove component compartment cover (2)
3	Unplug connector (X22) in the right of the component compartment
4	Unplug connector (A2) at fuse and relay module (K40/4)
5	Unplug connector (A1) at fuse and relay module (K40/4)
6	Separate plug connection of injection pump (Y23/1) at component partition	Use a screwdriver to press security catch
7	Pull out rubber seal of splash panel and remove cables behind trim panel
8	Disconnect cable of intake air temperature sensor (B17)
9	Unplug connector of glow output stage (N14/2)	Pull cable through below windscreen washer reservoir (3); slacken securing bolt for this purpose and raise reservoir
10	Disconnect wiring harness (G2) of generator
11	Remove bottom part of noise encapsulation (4)
12	Unbolt terminal block (X4) circuit 30 in left footwell	Unbolt cable at the outside of the body; pull off plastic cap for this step and unbolt bracket
13	Unbolt engine ground (W11/1) (ground strap)	Unbolt cable at transmission
14	Install in the reverse order