Removing and installing steering lock - AR46.10-P-0900C

MODEL 210 

Fig 1: Unscrewing Escutcheon From Instrument Panel And Claw-Type Wrench

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Protective Sleeve, Steering Lock Part, And Parking Lock Wire Cable

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 3: Identifying U-Bolt, Steering Lock Part And Protective Sleeve

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 4: Identifying Ignition Starter Switch And Parking Lock Valve

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 5: Identifying Main Shaft In Steering Lock Part

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 6: Identifying Mounting Bolt And Parking Lock Wire Cable

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Removing, installing
1	Remove cover under instrument panel		AR68.10-P-1500F
2	Unscrew escutcheon (36a) from the instrument panel using claw-type wrench (020)		Figure
3.1	Pull transponder coil off lock cylinder	Vehicles with stage 2a drive authorization system (DAS 2a) as of 6/96	AR80.30-P-4515F
4	Disconnect connector (S2/1x1) in lock cylinder position "1"
5.1	Unhook parking lock wire cable (37a) at the protective sleeve	Vehicles with automatic transmission
6	Remove protective sleeve (36d) by pressing in the locking pin in the steering lock part (37)	The lock cylinder must be in position "1"
	U-bolt (010)for assembling protective sleeve on steering lock		WF58.50-P-4610-01A
7	After unscrewing the nut, pull the mounting bolt (37m) out of the steering lock (37) up through the recess in the box section	Beforehand in the case of the electrically adjustable jacket tube:  Loosen horn/airbag clock spring contact a and turn signal indicator switch, Remove jacket tube trim, a Remove instrument cluster, a Unscrew the upper jacket tube suspension, a Loosen the jacket tube suspension and a lower jacket tube as far as possible
8	Pull steering lock part (37) out of the jacket tube
	The main shaft (37f) in the steering lock part must not be turned out of position "1" otherwise the steering lock locks in position	When the steering lock is installed and locked in position:  The mounting bolt can only be pulled out of the jacket tube by damaging the steering lock beyond repair. When the steering lock is removed and locked in position:  ↓
		Unlock steering lock	AR46.10-P-0900-01A
9	Remove ignition/starter switch (S2/1) from the protective sleeve (36d)	The parking lock valve (37h) for the parking lock interlock is clipped onto the ignition/starter switch
10	Install in reverse order

Fig 7: Identifying Claw-Type Wrench (210 589 00 07 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.