Retrofitting weapons compartment - AN68.30-P-0001A

MODEL 210.0 

Fig 1: Identifying Weapons Compartment Components

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Installing
	Protect removed parts from contamination
1	Insert equipment compartment (2) and weapons compartment (1) into load compartment	Weapons compartment (1) without foam insert. The precise position of the weapons compartment (1) depends on the dent of the equipment compartment (2); as a guideline the rear hole should be approx. 145 mm from the loading edge.
2	Mark holes and contours of the weapons compartment on paneling of trunk floor	Use weapons compartment (1) as drilling and cutting template. Install markings for mounting holes with a sharp tool through paneling on trunk floor
3	Remove weapons compartment (1) and trunk floor paneling
4	Drill holes	When drilling ensure that the rear muffler shield located below is not be damaged.
5	Repair corrosion protection at holes	See Paintwork Manual.
6	Install pull-in nuts	M8 pull-in nut
7	Cut off trunk floor paneling along marked contour	Drill 12 mm dia. holes for mounting the weapons compartment corresponding to the markings at section B ø with punching iron.
8	Position section B of trunk floor paneling together with weapons compartment (1) and screw tight.	Move section B of trunk paneling and weapons compartment (1) so that they coincide. Fasten weapons compartment with suitable washers and screws.
9	Insert section A of trunk floor paneling
10	Insert equipment compartment (2)

Parts ordering notes

Part no.	Designation	Quantity
A 202 840 10 62	Weapons compartment with mounting material	1