Electrical headlamp range adjustment (HRA) diagnosis, function check of actual values - AD82.10-P-3002A

MODEL 208, 210 as of 1.6.98 with CODE (612) Xenon headlamp unit 

	Risk of death  caused by high voltage levels present at xenon headlamps. Risk of explosion/risk of fire  due to highly flammable materials in the area of damaged xenon bulbs Risk of injury  from UV light, hot components at xenon headlamps and glass splinters when xenon bulbs crack Risk of poisoning  from inhaling mercury vapors and from swallowing/skin contact with poisonous salts and mercury compounds	Do not come into contact with parts that are under high voltage. Persons with active electronic implants  (e.g. heart pacemakers) must never work on xenon headlamps. Switch off entire lighting system. Wear insulating safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure the work area is adequately ventilated.	AS82.10-Z-0001-01A
	Electrical headlamp range adjustment (HRA) diagnosis, previous knowledge		AD82.10-P-2000A
	Connecting and using test equipment		AD00.00-P-1000AZ
	Function check of actual values
	Actual value	Note	Remedy
01	Front/rear jounce	Readout: Front x.x mm Rear x.x mm The value increases with increasing vehicle load. The information is given relative to the position at the time communication is established.	Front axle sensor: ↓ AD82.10-P-6000-05A  Rear axle sensor: ↓ AD82.10-P-6000-04A
02	Front/rear level sensor signal	Readout: Front x.xx V Rear x.xx V The sensors supply a voltage of 0 to 5 volt. The zero position programming is only possible in the voltage range from 1.64 to 3.20 V.	Front axle sensor:↓ AD82.10-P-6000-05A  Rear axle sensor:↓ AD82.10-P-6000-04A
03	Voltage at circuit 15	Display: xx.x V Specified value: 11-14 V	Model 208: ↓ AD82.10-P-6000-02A Model 210:↓ AD82.10-P-6000-02B
04	Speed (ABS)	Display: x.x km/h Model 208: LF signal X47 Model 210: LR signal X62/21	Cables
05	Light signal	Display: ON/OFF Signal from light module (N7-1)	AD82.10-P-6000-03A