Adjusting ball point position - AR40.20-P-0321A

MODEL 129 

Fig 1: Adjusting Ball Point Position - Model 129 (1 Of 2)

Fig 2: Adjusting Ball Point Position - Model 129 (2 Of 2)

1	Adjust the ball point position at the steering idler arm (26) by inserting or removing the washer (26a).	If the ball point position cannot be adjusted at the steering idler arm, a correction to the ball point position can be made at the pitman arm by offsetting (a) on the splined section of the pitman arm shaft.	*BE40.20-P-1001-05A
		The thread of the hexagon bolt must project at least another 1 mm beyond the hexagon nut. If the ball point position cannot be adjusted ↓.	*BA40.20-P-1001-01A
		Check steering idler arm bearing.	ra60001290110x

BALL POINT POSITION

Number	Designation		Model 129
BE40.20-P-1001-05A	Ball point position	mm	23±2

CHASSIS ALIGNMENT CHECK

Number	Designation		Model 129
BA40.20-P-1001-01A	Nut on steering idler arm	Nm	180