Remove/install viscous fan clutch - AR20.40-P-5660HW
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2000 Mercedes-Benz C43, 2000 Mercedes-Benz C280, 2000 Mercedes-Benz C230, 1999 Mercedes-Benz C43, and 1999 Mercedes-Benz C280. However, it is still accessible from the selected car via links, so may be relevant.
ENGINE 601 in MODEL 124, 201
ENGINE 602 in MODEL 124, 201
ENGINE 603 in MODEL 124, 126, 140
| Remove, Install | |||
|---|---|---|---|
| 1.1 | Remove the fan shroud (3) and put it above the fan (1) | For vehicles with a one-piece fan shroud | |
| 1.2 | Turn the fan shroud ring (3a) from the locking studs on the fan shroud, remove together with the fan shroud | In case of vehicles with split fan shroud |
|
| 2 | Insert the counterholder (9) at the coolant pump belt pulley | Figure | |
| 3 | Unscrew the viscous fan clutch (2) with the fan (1) and remove | Figure | |
| Fig 5 | |||
| Figure | |||
| *BA20.40-P-1002-01A | |||
| *BA20.40-P-1003-01A | |||
| 4 | Unscrew the fan (1) at the viscous fan clutch (2) | ||
| *BA20.40-P-1001-01A | |||
| 5 | Install in the reverse order |
| Number | Designation | Engines 601, 602 except 602.98, 603 | |
|---|---|---|---|
| BA20.40-P-1001-01A | Bolt of fan to viscous fan clutch | NM | 10 |
| BA20.40-P-1002-01A | Tighten bolt between viscous fan clutch and bearing liner using approved special tool | NM | 40 |
| BA20.40-P-1003-01A | Tighten bolt between viscous fan clutch and bearing liner using screwdriver and torque wrench | NM | 45 |