Connecting compression tester - AR01.10-P-0010-01BG

Fig 1: Identifying (201 589 00 99 00) Electrical Connection Set

Fig 2: Identifying (124 589 36 63 00) Adapter Cable

Fig 3: Identifying (001 589 76 21 00) Compression Tester

Connecting power supply to compression tester 

1. Open cover (1) of terminal block (X12/3) at left wheel-housing.
2. Connect clamp (A) of compression tester to terminal block (X12/3).
   Fig 4: Identifying Cover Of Terminal Block & Clamp

   

Models up to approx. 06/97 

1. 3.1 Separate plug connection (X22/2) of engine compartment / engine circuit 50 in right of component compartment.
2. 4.1 Connector adapter cable (01) with plug connection (X22/2).
3. 5.1 Connect cable (01) to cable of compression tester.
   Fig 5: Identifying Connector Adapter Cable And Plug Connection

   

Models as of approx. 06/97 

1. 3.2 Detach connector (A1) at fuse and relay module (K40/4) in right of component compartment.
2. 4.2 Connect cable (1) to female connector (A1) of contact 6.
3. 5.2 Connect cable (1) to cable (2) of compression tester.
   Fig 6: Identifying Female Connector, Fuse And Relay Module