Removing and installing rear window wiper motor - AR82.30-P-6900A
MODEL 202.07/08/18
Location of components
| Removal | |||
| Injury hazard from pinching and crushing, in extreme cases extremities can even be cut off when caught in windshield wiper mechanism. | Always remove ignition key before working on windshield wiper mechanism. | AS82.30-Z-0001-01A | |
| 1 | Remove ignition key | ||
| 2 | Remove door liner on tailgate | AR68.30-P-1050A | |
| 3 | Open cover (1) | ||
| 4 | Unscrew wiper arm nut (2) | ||
| 5 | Swing wiper arm back and remove | ||
| 6 | Disconnect electrical connector (3) | ||
| 7 | Pull washing water line off of connection fitting (4) | ||
| 8 | Unscrew screw for rear window wiper motor | ||
| 9 | Remove rear window wiper motor (M6/4) | ||
| Installation | |||
| 1 | Move wiper motor to park position | ||
| 2 | Install rear window wiper motor (M6/4) |
NOTE:
If necessary replace rubber grommet on rear window.
|
|
| 3 | Screw in screw for rear window wiper motor (5) (M6/4) | ||
| 4 | Attach washing water line to connection fitting (4) | ||
| 5 | Reconnect electrical connector (3) | ||
| 6 | Attach wiper arm |
NOTE:
Attach wiper arm so that wiper arm points toward left (driver's side).
|
|
| 7 | Fasten wiper arm with nut (2) | ||
| 8 | Close cover (1) | ||
| 9 | Reinstall door liner on tailgate | AR68.30-P-1050A |