Removing and installing electronic steering lock - AR46.10-P-0910B

MODEL 208 

Fig 1: Identifying Electronic Steering Lock Remove/Install Components - Model 208 (1 Of 2)

Fig 2: Identifying Electronic Steering Lock Remove/Install Components - Model 208 (2 Of 2)

	Removing, installing
Installation	Replace self-locking nuts and bolts
1	Remove steering wheel		AR46.10-P-0100C
2	Remove instrument cluster		AR54.30-P-6015EA
3	Remove cover below instrument panel		AR68.10-P-1500K
4	Unscrew steering column trim (99)
5	Detach jacket tube fixing	Installation:  First of all fit on all nuts and bolts.
		Tighten the bottom nuts (arrows) first of all.	*BA46.10-P-1001-03A
		Bolts (91a).	*BA46.10-P-1002-03A
6	Unscrew nut (37n) of securing bolts (37m)		*BA46.10-P-1009-03A
N	Turn electronic ignition key into position "1" and lift securing bolt (37m) up and off	The securing bolt can only be taken off if the electronic steering lock is unlocked.
8	Separate plug connection (37p)
9	Take electronic steering lock (N36/5) out of steering column
10	Install in the reverse order

JACKET TUBE

Number	Designation		Model 208
BA46.10-P-1001-03A	Lower nut, jacket tube to body	Nm	20
BA46.10-P-1002-03A	Upper bolt, jacket tube to body	Nm	20
BA46.10-P-1009-03A	Nut of securing bolt of electronic steering lock to steering column	Nm	10