Checking alignment of steering knuckle (removed) - AR40.30-P-0451D

MODEL 210.081 /082 /083 /281 /282 /283 

Left steering knuckle shown 

Fig 1: Checking Alignment Of Steering Knuckle (Model 210.081 /082 /083 /281 /282 /283) - Left Steering Knuckle Shown (1 Of 4)

Fig 2: Checking Alignment Of Steering Knuckle (Model 210.081 /082 /083 /281 /282 /283) - Left Steering Knuckle Shown (2 Of 4)

Fig 3: Checking Alignment Of Steering Knuckle (Model 210.081 /082 /083 /281 /282 /283) - Left Steering Knuckle Shown (3 Of 4)

Fig 4: Checking Alignment Of Steering Knuckle (Model 210.081 /082 /083 /281 /282 /283) - Left Steering Knuckle Shown (4 Of 4)

	Removal, installation
1	Remove and install steering knuckle		AR33.25-P-0400D
	Measuring
2	Place steering knuckle with wheel hub or brake disc installed on parallel supports		*WH58.30-Z-1015-12A
3	Scan and note height dimension "A" as comparative dimension with a height marking device	Measure at the flat surface of the brake caliper mounting.	*WH58.30-Z-1016-12A
4	Scan and note height dimension "B1-B3" at the lowest point of the each bore.	The test values result from the difference in height dimension "A" to the height dimensions: "B1" = Bearing of supporting joint "B2" = Bearing of upper wishbone "B3" = Bearing of steering knuckle arm/tie rod	*BE40.30-P-1001-01A