Replacing rear mount of lower wishbone - AR33.20-P-0527B

MODEL 170, 202 

Fig 1: Identifying Trust Piece And Sleeve Installed On Rear Mount Of Lower Wishbone - Model 170, 202

Fig 2: Identifying Rear Mount Of Lower Wishbone Rubber Mount - Model 170, 202

Fig 3: Identifying Rubber Mount And Sleeve Installed On Rear Mount Of Lower Wishbone - Model 170, 202

	Removal
	Risk of injury  due to rubber mounts or bearing parts which loosen suddenly during the pressing-out/pressing-in process and then fly around in an uncontrolled manner.	Screen the danger area by means of suitable arresting device (basket, skeleton container). Also ensure that there are only authorized persons in the danger area.	AS00.00-Z-0014-01A
1	Remove lower wishbone		AR33.20-P-0510B
2	Clamp wishbone in vise.	Use aluminum jaws
3	Pull out rubber mount using thrust piece (012b) and sleeve (012c)		Figure
4	Clean mounting bores for mount in wishbone	Smear rubber mount with a thin film of lubricant Do not use any oil or grease containing acid.	*BR00.45-Z-1010-06A
	Installation
5	Insert rubber mount (17) in the wishbone from the back (viewed in direction of travel) and pull in up to the stop.		Figure
	Use sleeve (012d) and sleeve (012e)	The flats (arrow) of the rubber mount must be at an angle of 90° to the center weld seam of the wishbone.
6	Install lower wishbone		AR33.20-P-0510B

Fig 4: Identifying Special Tool (202 589 01 43 00)

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1010-06A	Anti-friction agent	A 000 989 03 67