Detaching and attaching handle and latching mechanism for manual steering wheel adjustment - AR46.15-P-0550-07A

Detaching, attaching 

1. Using a suitable screwdriver in the lever shaft, press back plastic locking pin (95c) in the handle (95) and remove.
2. Press lever shaft out of handle.
   Fig 1: Identifying Plastic Locking Pin And Handle

   
3. Using a suitable screwdriver at the bracket, press back plastic locking pin (arrow) of the latching mechanism (95a) and remove.
4. Remove latching mechanism (95a) upwards from bracket.
   Fig 2: Pressing Back Plastic Locking Pin Of Latching Mechanism

   
5. Unscrew hexagon socket bolt (arrow) and remove with handle.
6. Install in reverse order

   Installation : 

   Press plastic locking pin completely into the lever shaft or into the hole in the bracket.

   Fig 3: Locating Hexagon Socket Bolt