Installing tilting/sliding roof panel - AR77.20-P-1000-02EA

Electrically operated steel tilting/sliding roof (code 412b)

TEST AND ADJUSTMENT VALUES FOR TILTING/SLIDING ROOF

Number	Designation			Model 202
BE77.20-P-1001-01A	Joint gap	Front of tilting/sliding roof panel	mm	0,15
BE77.20-P-1001-01A	Joint gap	Side and rear of tilting/sliding roof panel	mm	0,30

Special tools

Fig 1: Identifying Adjustment Gauge (140 589 04 21 00)

Fig 2: Identifying Installation Pliers (124 589 00 37 00)

Insert adjustment gauge (7) into holder (8) and arrest in direction of arrow.
NOTE: The adjustment gauge (7) ensures that the holder (8) and tilting/sliding roof panel (1) are positioned properly when installed.

Fig 3: Inserting Adjustment Gauge Into Holder
Position tilting/sliding roof panel (1), loosely screw on nuts (3) and screw (4).

Fig 4: Identifying Tilting/Sliding Roof Panel Nuts And Screw
Slightly tension tilting/sliding roof panel (1) with installation pliers (9), tighten nuts (3) and screw (4).
Remove adjustment gauge (7) and installation pliers (9).
Check tilting/sliding roof for proper function.
Check joint gaps around closed tilting/sliding roof panel (1) from outside.

Fig 5: Tensioning Tilting/Sliding Roof Panel Installation Pliers