Setting distance - AR54.30-P-5345EA
MODEL 202 except CODE (491) USA version
| It is possible to set the odometer display only once during the first 300 km/miles or 10 km in the case of the |
|||
| 1 | Turn key in steering lock to position "2" | ||
| 2 | Press knob (1) and hold | A signal sounds after about 10 s and the display is set to 000000 | |
| 3 | Turn key to position "0" and then back to position "2" | "Prog" appears in the trip counter display 0 - - - - - appears in the odometer display | |
| 4 | Release knob (1) | ||
| 5 | Pull out knob (2) and turn to the left in direction of arrow | Digit of 1st position is set to 1 | |
| 6 | Release knob (2), pull out again and turn to the left | Digit of 1st position is set to 2 ↓ Repeat operation until the desired digit is set |
|
| 7 | Pull out knob (2) and turn to the right in opposite direction of arrow | The digit 0 appears in the 2nd position ↓ Set desired digit as described for setting the 1st position ↓ To set the desired digits for positions 3 to 6, proceed as described for the 1st and 2nd positions |
|
| 8 | Store odometer reading; press knob (1) to do this and turn key to position "0" | ||
| 9 | Release knob (1) | ||
| 10 | Check setting; turn key to position "2" to do this | If entry is incomplete or if odometer entry of more than 300 km/miles or 10 km for |