LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1997 >> C280 >> Repair and Diagnosis >> Accessories & Equipment >> Wiring System (Data Link Connectors, Pwr Dist., Grnd Dist.) >> Electrical System, Equipment & Instructions -- 202 Chassis >> Testing & Repair >> Disconnect/connect battery's ground cable - AR54.10-P-0003R

Disconnect/connect battery's ground cable - AR54.10-P-0003R

MODEL 230.4 

Fig 1: Identifying Ground Cable - Models 230.4
G04715686
  Disconnect, connect    
DANGER Risk of explosion  caused by oxyhydrogen gas. Risk of poisoning and caustic burns  caused by swallowing battery acid. Risk of injury  caused by burns to skin and eyes from battery acid or when handling damaged lead-acid batteries No fire, sparks, open flames or smoking. Wear acid-resistant gloves, clothing and safety glasses. Only pour battery acid into suitable and appropriately marked containers. AS54.10-Z-0001-01A 
NOTES Notes on battery   AH54.10-P-0001-01A 
IMPORTANT Notes on AGM battery   AH54.10-P-0002-01A 
1 Switch off all electrical consumers    
2.1 Switch TELE AID to Service mode On vehicles with code (855) TELE AID
IMPORTANT This prevents discharge of the additional battery and an emergency call signal being sent.
 
3 Switch off the ignition and remove the transmitter key from the EIS control unit IMPORTANT On vehicles with code (889) Keyless Go, press the Keyless Go start/stop button repeatedly until the ignition is switched off. Remove the Keyless Go transmitter card or transmitter key from the vehicle and store beyond the reach of the transmitter (min. 2 m).  
4 Unhook trunk partition    
5 Remove spare wheel cover    
6 Loosen nut and disconnect ground line (1) from the on-board electrical system battery (G1)    
7 Open engine hood and raise to vertical position   AR88.40-P-1000R
8 Slacken nut and disconnect ground cable (2) from starter battery (G1/4) NOTES Before disconnecting the ground line (2) from the starter battery (G1/4) the ground line (1) must be disconnected from the on-board electrical system battery (G1) otherwise the components of the electrical system may become damaged.  
9 Connect in the reverse order. IMPORTANT All electrical consumers must be switched off.  
10 Perform basic programming   AR00.19-P-0200R
11.1 Read fault memory, erase if necessary On model 230.4 up to 14.1.04.  
REFER TO SELF-DIAGNOSTIC SYSTEMS Connect STAR DIAGNOSIS and read out fault memory   AD00.00-P-2000-04A
    STAR DIAGNOSIS diagnosis system *WH58.30-Z-1048-13A 
COMMERCIALLY AVAILABLE TOOLS

Number Designation
WH58.30-Z-1048-13A STAR DIAGNOSIS diagnosis system, Compact Passenger Car 6511 1801 00