Adjusting friction torque of steering gear - AR46.20-P-0100-01A
MODIFICATION NOTES
| 5.10.06 | Locknut of friction torque adjusting bolt to steering worm | Model 240 | *BA46.20-P-1005-01A |
TEST VALUES FOR STEERING GEAR
| Number | Designation | Model 129 | Model 140 | Model 170 | |
|---|---|---|---|---|---|
| BE46.20-P-1001-01A | Total friction torque of steering gear in center range | Ncm | 100-160 | 100-160 | 100-160 |
TEST VALUES FOR STEERING GEAR
| Number | Designation | Model 202 | Model 208 | Model 240 | |
|---|---|---|---|---|---|
| BE46.20-P-1001-01A | Total friction torque of steering gear in center range | Ncm | 100-160 | 100-160 | 100-160 |
| Number | Designation | Model 129 | Model 140 | Model 170 | Model 202 | |
|---|---|---|---|---|---|---|
| BA46.20-P-1005-01A | Locknut of friction torque adjusting bolt to steering worm | Nm | 60 | 60 | 60 | 60 |
| Number | Designation | Model 208 | Model 240 | |
|---|---|---|---|---|
| BA46.20-P-1005-01A | Locknut of friction torque adjusting bolt to steering worm | Nm | 60 | 45 |
- Loosen jam nut (23m).
- Turn the adjusting screw (23l) in stages by 1/4 revolution.
A = smaller play
= higher friction value
B = larger play
= smaller friction value
- Tighten jam nut (23m)
- Check adjustment after tightening the jam nut, repeat the adjustment if necessary