Remove/install lamp unit - AR82.10-P-4730EDD
MODEL 170 up to 31.7.99 with CODE (612) Xenon headlamp unit
Fig 1: Identifying Lamp Unit Remove/Install Components - Model 170 Up To 31.7.99 With Code (612) Xenon Headlamp Unit
| Remove/install | |||
| Risk of death
caused by high voltage levels present at xenon headlamps. Risk of explosion/fire hazard through highly flammable material in the area of damaged xenon bulbs. Risk of injury through UV light, hot components on xenon headlamps and glass splinters when xenon bulbs burst. Risk of poisoning through inhalation of mercury vapor and swallowing of or skin contact with toxic salts and mercury compounds. |
Do not come into contact with parts that are under high voltage. Persons with active electronic implants (e.g. heart pacemakers) must never work on xenon headlamps. Switch off complete lighting system. Wear insulating safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the hazard area. Ensure that the workplace is sufficiently ventilated. | AS82.10-Z-0001-01A | |
| 1 | Switch off ignition | ||
| 2 | Remove left turn signal lamp (E6/1) or right turn signal lamp (E6/2) | ||
| 3 | Detach electrical connection (3) from left turn signal lamp (E6/1) or right turn signal lamp (E6/2) | ||
| 4 | Remove screws (5) and (7) | ||
| 5 | Detach electrical connection (2) (lamp unit) and electrical connection (4) (headlamp range adjustment motor) on left front lamp unit (E1) or right front lamp unit (E2) | ||
| 6 | Carefully remove left front lamp unit (E1) or right front lamp unit (E2) to front | ||
| 7 | Install in the reverse order | Steps 7 up to 1. | |
| 8 | Set zero position on left front lamp unit (E1) or right front lamp unit (E2) | ||
| Checking | |||
| 9 | Check and correct headlamp adjustment | ||
| Model 170 except CODE (491) USA version. | AP82.10-P-8260A |