Removing and installing front rubber mounts of rear axle mounting - AR35.10-P-0040-02D

Fig 1: Identifying Removal/Installation Tool (201 589 10 43 00)

Removing rubber mount 

1. Press rubber mount out of rear axle carrier using removal tool (01c, 01d, 01e).

   

   Before inserting the collar (01e) press the rear axle carrier downwards slightly using a suitable tool, if necessary

   Shown on model 129 

   Fig 2: Identifying Collar And Removal Tool - Shown On Model 129

   

   Installing rubber mount 

2. Smear periphery of rubber mount (1a) with lubricant.
3. Draw in rubber mount (1a) using installation tool (01c, 01h, 01i).

   Shown on model 129 

   Fig 3: Identifying Rubber Mount And Installation Tool - Shown On Model 129