Remove/install thrust arm - AR35.20-P-0113P

MODELS 203, 209.3 /4 

Fig 1: Identifying Torque Strut Remove/Install Components - Shown On Model 203, 209.3 /4

Fig. item etc.	Work instructions
	Risk of death  due to the vehicle slipping off or toppling off the lifting platform	Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
Installation	Replace self-locking nuts
	Torque strut	Self-locking nut, torque strut to rear axle carrier.	*BA35.20-P-1001-05A
		Self-locking nut, torque strut to wheel carrier.	*BA35.20-P-1002-05A
5	Torque strut	When tightening nuts, move rear axle shaft to approximately horizontal position.
5 g	Torque strut cover	Note correct installation position.

TORQUE STRUT

Number	Designation			Model 203	Model 209
BA35.20-P-1001-05A	Self-locking nut, torque strut to rear axle carrier		NM	70	50
			∠ °	-	45
BA35.20-P-1002-05A	Self-locking nut, thrust arm to wheel carrier	M10	NM	-	-
		M12	NM	70	50
			∠ °	-	45