Remove/install supporting joint on wheel carrier - AR35.20-P-0116-01B

Fig 1: Identifying Extractor And Insertion Tool (202 589 00 43 00)

Remove 

1. Pull supporting joint (7a) out of wheel carrier (7) using removal and installation tool (06c, 06h, 7i) and remove.

   The recess in the counter sleeve (06i) must face outwards to the wheel carrier.

   Fig 2: Identifying Supporting Joint, Wheel Carrier, Clamping Bolt, Thrust Piece And Counter Sleeve

   

Install 

2. Attach removal and installation tool (06c, 06h, 06i) with supporting joint to wheel carrier (7).
3. Pull supporting joint (7a) into wheel carrier from behind using removal and installation tool .
   Fig 3: Identifying Supporting Joint, Wheel Carrier, Clamping Bolt, Thrust Piece, Counter Sleeve And Special Tools

   

Wheel carrier with surfaces machined on both sides

The supporting joint must protrude the same distance on both sides (centrally from boss).

Wheel carrier with chamfer

The supporting joint outer sleeve must fit flush with the chamfer of the small dia. on the wheel carrier (arrows).

Fig 4: Locating Chamfer On Wheel Carrier