Driving out and driving in ASD differential pin and roll pin - AR35.41-P-0560-02C

Fig 1: Identifying Drift Punch (123 589 06 15 00)

Fig 2: Identifying Drift Punch (126 589 02 15 00)

Removal 

1. Using a suitable drift, drive roll pin (19) for the differential pin (16) out of the differential housing (13).
2. Using drift punch 123 589 06 15 00 for 185 mm dia. crown wheel or 126 589 02 15 00 for 210 mm dia. crown wheel, drive differential pin (16) out of differential housing.

   Installation 

3. Using drift punch 123 589 06 15 00 for 185 mm dia. crown wheel or 126 589 02 15 00 for 210 mm dia. crown wheel, drive differential pin (16) into differential housing, paying attention to the bore for the roll pin (19).
4. Drive in roll pin (19) until it seats centrally in the differential pin.

   Replace roll pin (19).

   Fig 3: Identifying Differential Housing, Bevel Gear, Pin, Side Gear, Roll Pin And Friction Washer