Adjust rear door - AR72.12-P-0650E
MODEL 202
| Adjust | |||
| 1 | Remove striker eye | ||
| 2 | Check gap dimensions at door all the way around | Figure | |
| Model 202.01/02/12 | AR60.00-P-0700-01E | ||
| Model 202.07/08/18 | AR60.00-P-0700-01EA | ||
| 3 | Loosen bolts (10) on B-pillar, tighten and adjust by moving rear door, adjust gaps | *BA72.12-P-1001-01A | |
| Seam sealing following repair | AR97.10-P-4000E | ||
| 4 | Loosen bolts (11), tighten and adjust contour on hinge side by moving rear door | Door paneling (D) should be flush with driver's door contour or should be located max. 1 mm deeper |
*BA72.12-P-1001-01A |
| 5 | Bolt on striker eye | ||
| 6 | Close rear door completely and adjust contour of striker eye by moving striker eye | Door paneling (E) should be flush with contour of rear fender or should extend max. 1 mm | |
| 7 | Tighten striker eye | *BA72.12-P-1003-01A | |
| 8 | Check contour and fit on window frame (F) to roof paneling and rear pillar, adjust if necessary. | The outer lip of the door sealing frame should be flush with the edge of the roof paneling. | |
| 9 | Check rear door for easy motion |
TEST AND ADJUSTMENT VALUES, GAP DIMENSIONS AT HOODS, DOORS AND COVERS
| Number | Designation | Model 202.01/02/033/ 12/13 | Model 202.07/08/093 /18/19 | |||
|---|---|---|---|---|---|---|
| BE60.00-P-1002-01A | Gap dimension | Front door to A-pillar | Dimension "B" | mm | 6.0 (+1) | 6.0 (+1) |
| Front door to fender | Dimension "H" | mm | 5.0 (+1) | 5.0 (+1) | ||
| Front door to rear door | Dimension "I" | mm | 6.0 (+1) | 6.0 (+1) | ||
| Front door to roof | Dimension "C" | mm | 6.0 (+1) | 6.0 (+1) | ||
| Rear door to upper side section | Dimension "D" | mm | 6.0 (+1) | - | ||
| Rear door to lower side section | Dimension "J" | mm | 5.0 (± 0.5) | 5.0 (± 0.5) | ||
| Fender to A-pillar | Dimension "Q" | mm | - | - | ||
| Front door to rear fender | Dimension "P" | mm | - | - | ||
| Fig., see | AR60.00-P-0700-01E | AR60.00-P-0700-01EA | ||||
| Number | Designation | Model 202 | |
|---|---|---|---|
| BA72.12-P-1001-01A | Bolts to door hinge | Nm | 37 |
| BA72.12-P-1003-01A | Bolts to striker eye | Nm | 28 ± 4 |