Connecting and disconnecting tester at rear axle distributor fitting - AR32.31-P-0510-01A
| Risk of injury to skin or eyes due to hydraulic fluid spraying out under high pressure. Risk of poisoning due to consuming hydraulic fluid. | Before starting work on the hydraulic system, depressurize the system. Wear protective clothing and safety glasses | AS00.00-Z-0013-01A |
| Number | Designation | Model 129 with electronic level control/ADS II | ||
|---|---|---|---|---|
| BA32.31-P-1001-01A | Oil drain plug on rear axle distributor fitting (reference value) | M10x1 | Nm | 14 |
Connecting tester
- Mount test hose (038e) and bleed screws (038n) on distributor (038r) of tester (038).
- Unscrew oil drain plug on distributor fitting (57) at rear axle (cover for fuel pump assembly in the area of the rear axle removed).
- Connect tester (038) with test hose (038e) in place of the oil drain plug on distributor fitting (57).
Disconnecting tester
Danger due to oil spraying out !
- Connect oil drain hose to bleed screw (038n) on tester (038).
- Open bleed screw (038n) slowly and collect the oil in a clean container.
The oil collected can be re-used.
- Close bleed screw (038n) again.
- Disconnect tester (038) with test hose.
- Screw oil drain plug onto distributor fitting (57), observe tightening torque.