Extended vehicle network (EVN) diagnosis fault memory wiper system (B1000, B1010, B1011, B1057, B1059, B1141, B1142, B1217, B1483, B1484, B1643, B1729)- AD00.19-P-4000A
MODEL 202 as of 1.6.97, 208, 210.081 /281, 210 as of 1.3.97
| Extended vehicle network (EVN) diagnosis, previous knowledge | AD00.19-P-2000A | |||
| I | Fuses in order. | |||
| II | Ignition: ON | |||
| III | Connect Hand-Held Tester to data link connector (DTC readout) (X11/4) in accordance with connecting diagram | AD00.00-P-1000AZ | ||
| IV | Voltage supply of control modules and CAN data buses in order | AD00.19-P-6000A | ||
| V | All CAN data buses must be connected | |||
| Fault memory | ||||
| Fault code |
Possible cause | Notes | Remedy | |
| B1000 | Electronic ignition switch control module (N73) |
|
||
| B1000 | Overhead control panel control module (N70) |
|
||
| B1000 | Driver-side signal-acquisition and actuation module (SAM) (N10/1) |
|
||
| B1010 | Undervoltage | AD00.19-P-6000-01A AD00.19-P-6000-02A AD00.19-P-6000-03A AD00.19-P-6000-04A AD00.19-P-6000-05A AD00.19-P-6000-06A AD00.19-P-6000-07A AD00.19-P-6000-08A AD00.19-P-6000-09A AD00.19-P-6000-10A AD00.19-P-6000-11A |
||
| B1011 | Overvoltage | AD00.19-P-6000-01A AD00.19-P-6000-02A AD00.19-P-6000-03A AD00.19-P-6000-04A AD00.19-P-6000-05A AD00.19-P-6000-06A AD00.19-P-6000-07A AD00.19-P-6000-08A AD00.19-P-6000-09A AD00.19-P-6000-10A AD00.19-P-6000-11A |
||
| B1057 | CAN: Communication between electronic ignition switch control module (N73) and overhead control panel control module (N70) faulty | AD00.19-P-6000-30A AD00.19-P-6000-30B AD00.19-P-6000-30C AD00.19-P-6000-31A AD00.19-P-6000-31B AD00.19-P-6000-31C AD00.19-P-6000-32A AD00.19-P-6000-33A AD00.19-P-6000-33B AD00.19-P-6000-34A AD00.19-P-6000-35A AD00.19-P-6000-45A AD00.19-P-6000-45B AD00.19-P-6000-45C AD00.19-P-6000-46A AD00.19-P-6000-46B AD00.19-P-6000-46C AD00.19-P-6000-47A AD00.19-P-6000-48A |
||
| B1059 | CAN: Communication between electronic ignition switch control module (N73) and driverside signal-acquisition and actuation module (SAM) (N10/1) faulty | AD00.19-P-6000-45A AD00.19-P-6000-45B AD00.19-P-6000-45C AD00.19-P-6000-46A AD00.19-P-6000-46B AD00.19-P-6000-46C AD00.19-P-6000-47A AD00.19-P-6000-48A |
||
| B1141 | HCS switch signal > 25 seconds | AD00.19-P-6000-74A | ||
| B1142 | Rear wipe/wash switch signal > 25 seconds | AD00.19-P-6000-73A | ||
| B1217 | 000 | Rain sensor (B38), no communication | AD00.19-P-6000-64A AD00.19-P-6000-65A AD00.19-P-6000-66A |
|
| B1217 | 001 | Rain sensor (B38), defective |
|
|
| B1217 | 002 | No windshield adaption |
|
|
| B1217 | 003 | Excess temperature |
|
|
| B1217 | 004 | Intermittent fault |
|
|
| B1217 | 006 | Wiper system not calibrated |
|
|
| B1483 | Actuation of windshield washer relay (K40/2k3) |
AD00.19-P-6000-68A AD00.19-P-6000-69A AD00.19-P-6000-70A |
||
| B1484 | Actuation of windshield washer relay (K40/2k3) |
AD00.19-P-6000-61A | ||
| B1643 | Rain sensor, no communication | AD00.19-P-6000-65A AD00.19-P-6000-66A AD00.19-P-6000-67A |
||
| B1729 | PSE control module (combined) (A37) |
|
||