Remove grooved ball bearing in rear of transmission housing - AR27.50-P-0601-01A

Fig 1: Identifying Puller (001 589 50 33 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 2: Identifying Clamping Pliers ((140 589 06 34 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

1. Screw in clamping pliers in puller and tighten.
2. Position puller above bearing inner race.
3. Turning top part of puller counterclockwise (arrow) tightens clamping pliers (figure A).
4. Use puller to pull grooved ball bearing out of transmission housing (figure B).
   Fig 3: Identifying Turning Top Part Of Puller Counterclockwise

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
   Fig 4: Pulling Grooved Ball Bearing Out Of Transmission Housing

   Courtesy of MERCEDES-BENZ OF NORTH AMERICA.