Replace deep-groove ball bearing in intermediate shaft - AR33.30-P-0625-02A

Fig 1: Identifying Two-Armed Puller (000 589 88 33 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Commercially available tools

Number	Designation
WH58.30-Z-1009-02A	Pliers for circlip, inner

Removing

Take out circlip (35a) for grooved ball bearing (35) using pliers .

Fig 2: Identifying Circlip For Grooved Ball Bearing
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Detach grooved ball bearing (35) using puller (035).

Fig 3: Identifying Grooved Ball Bearing With Puller
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Install

Check circlip (35) and replace if necessary.
Ensure correct seat in groove.
Press in grooved ball bearing (35) using press.
For this purpose the grooved ball inner race must be underlaid with a shim.

Fig 4: Identifying Circlip
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.
Insert circlip (35a) for grooved ball bearing (35) using pliers.
Ensure correct seat in groove.

Fig 5: Identifying Circlip For Grooved Ball Bearing
Courtesy of MERCEDES-BENZ OF NORTH AMERICA.