LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 1996 >> E320 >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Air Bag Restraint System) >> Removal & Installation >> CLOCKSPRING Assembly >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 1997 Mercedes-Benz E420, 1997 Mercedes-Benz E320, and 1997 Mercedes-Benz E300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see SERVICE PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Remove driver air bag module. See DRIVER-SIDE AIR BAG MODULE . Remove steering wheel bolt. Using a puller, remove steering wheel. Disconnect lower clockspring connector (X28/4). See Figure. Turn 2 fixing screws (locating on clockspring) counterclockwise until clockspring cannot be rotated. Remove clockspring mounting screws as necessary. Disconnect all necessary electrical connectors. Remove clockspring assembly. To install, reverse removal procedure. Activate air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Perform system operation check to ensure system is functioning properly. See SYSTEM OPERATION CHECK .
scientia non olet · About LEMON Manuals